ESD Floor Maintenance
ZeroStat Coat Anti Static Floor Finish
Features:
- Highly abrasion resistance, scuff resistant
- Long lasting, reduced maintenance cost.
- High gloss, esthetically pleasing luster.
- Non flaking , Non slippery
- Low cost
- Low tribo-charge generation
- UL listed-Slip Resistant (as applied)
- Low Odor-Employee comfort!
- No formaldehydes or phthalates-SAFE!
- No alkalis, acids or ammonia-SAFE!
- Non flammable and water based yet provides the high luster and cleanliness demanded by many of today's high tech environment
- Low Odor, Low VOC's and Biodegradable while providing exceptional electrical conductivity
- Per EOS ESD 7.1: 1.0E07 to 1.0E09
- Electrostatic Decay Time EIA 541: <0.1 sec
ZeroStat Coat is a state-of-the-art, floor maintenance finish with inherent static-dissipating properties. It is specifically formulated for application in computer rooms, electronic assembly areas, telephone sub-stations and any other area where positive elimination of static electricity is a prime consideration. The unique static dissipating ingredient is actively linked to the chemical structure of the polymer system preventing washout or leaching of the static dissipating properties. Easy maintenance, good gloss, and durability are additional assets of this high-tech anti-static finish.
SPECIFICATIONS:
| Nonvolatile Solids | 20 +- 0.6% |
|---|---|
| Total Active | 24% |
| Resistivity-ASTM D257 | <10E08 RTG per 7.1 @ 40% Relative Humidity |
| Static Dissipation | 0.02 Second |
| pH | 8.7 - 9.0 |
| Gloss 60 0 | 80+ @ 3 coats |
| Color | Translucent white |
| Weight Per Gallon | 8.8 to 9.0 |
| Slip Resistance (ASTM) | 0.52 Minimum |
| Stability | 1 year minimum at room temperature |
| Freeze/Thaw Stability | 3 cycles minimum |
| Drying Time | 30 - 45 minutes |
| Water Resistance | Good |
| Gallon Coverage (Feet 2 ) | 1500 - 2000 |
| Removability (Gardner) | 75 cycles maximum |
Application:
This material is for use on sealed or non-porous substrates flooring materials. If the floor has been previously coated with a wax or finish (that may not be well bonded or is yellowed and dingy), strip old floor finish with StopESD’s ESD Stripper Emulsifier and rinse with clean water. Allow to dry thoroughly. Using a mop or wax applicator, apply thin even coats of StopESD Coat allowing finish to dry between coats. Two to four coats are recommended for optimum performance. Buffing is not required between coats.
Maintenance:
Dry mop floors with a untreated mop daily to remove loose dirt, sand and other abrasives. Damp mop as needed to remove soils which can degrade the coatings conductive properties and gloss
Technical Documents
» Why use an ESD floor finish?
» ZeroStat Coat Conductivity Study
» ZeroStat Coat MSDS Sheet
Ultra Con TM Elite - 2-LAYER High Temperature Rubber ESD Matting
Adjustable Elastic ESD Wrist Strap
